Roberts Radio CR9920 User Manual

CR9920  
3 Band Single Alarm  
TM  
Clock Radio with Pillow Talk REMOTE  
Off  
Alarm/  
T
M
PillowTalk  
3 Band Clock Radio  
Please read this manual before use  
Controls  
(Front)  
13  
14  
18  
150  
170  
210  
800 1000  
240 260  
PM  
540 600  
1300 1600  
88  
92  
96 100 104 106 108  
16  
15  
17  
19  
13. PMindicator  
17. Pillow Talk Remote plug  
14. LED dial pointer  
18. Remote Snooze/Sleep button  
19. Pillow Talk Remote loudspeaker  
15. Battery compartment (underside)  
16. Alarm indicator  
If you need any further advice, please call our Technical Helpline on :-  
02087580338(Mon-Fri)  
2
Switching on and setting the time  
Before using your clock radio you must first set the correct time.  
1. Placetheunitonaflatsurface.Plugthepowercordintothewallsocket  
and switch on.  
150  
540  
170  
600  
210  
240 260  
PM  
800 10 00  
1300 160 0  
88  
92  
96 10 0 10 4 10 6 10 8  
2. The clock display will flash 12:00.  
PM  
3. Press and hold down the Time Set button.  
r
u
o
H
4. Whilst holding down the Time Set button press the Hour, or Minute  
buttons to set the time. Release the buttons when the correct time is  
reached.Theclockusesa12hourdisplaywithaPMindicator.Ensure  
that the correct 12 hour cycle is selected.  
3
Listening to the Radio  
Off Buzz Auto On  
1. Turn on the radio by sliding the Function switch to the 'On' position.  
The LED dial pointer will light up indicating that the radio is  
switched on.  
150  
170  
210  
240 260  
540 600  
800 1000 1300 1600  
88  
92  
96 100 104 106 108  
2. Select therequiredwavebandusingtheWavebandselectorswitch.  
FM MW LW  
3. Tune in to the desired station by rotating the Tuning control. The  
station frequency is indicated by the LED dial pointer.  
150  
170  
210  
240 260  
Tuning  
The Wire aerial located on the rear of your clock radio is for FM  
reception. The wire should be fully extended and positioned for  
optimumreception.  
540 600  
800 1000 1300 1600  
88  
92  
96 100 104 106 108  
For MW and LW reception there is a built in ferrite aerial. Rotate the  
your clock radio to the position giving best reception.  
4. Adjust the volume by rotating the Volume control.  
Volume  
Off Buzz Auto On  
5. The radio can be switched off by sliding the Function switch to the  
'Off' position.  
If you need any further advice, please call our Technical Helpline on :-  
02087580338(Mon-Fri)  
4
Alarm  
The alarm can be set to wake you by either the buzzer or the radio.  
/O ff  
Alarm  
Setting alarm time  
1. Press and hold down the Alarm/Off button.  
r
u
o
H
2. WhilstholdingdowntheAlarm/Offbuttonpressthe Hour,orMinute  
buttons to set the time. Release the buttons when the correct alarm  
time isreached.Theclockusesa12hourdisplaywithaPMindicator.  
Ensure that the correct 12 hour cycle is selected.  
PM  
Alarm/Off  
Checking the alarm time  
1. To check alarm time, press and hold down the Alarm/Off button the  
display will show the alarm time.  
PM  
5
Setting the alarm to wake to buzzer  
Off Buzz Auto On  
1. Set the alarm time as previously described. Set theFunction switch  
to the 'Buzz' position. The Alarm indicator will light.  
The alarmwillsoundeverydayatthepresettimefor1hour 59minutes.  
ToturnoffthealarmuntilthenextdaypresstheAlarm/Offbutton. To  
turn off the alarm permanently set the Function switch to the 'Off'  
position.  
PM  
Setting the alarm to wake to radio  
1. Set the alarm time as previously described. Set theFunction switch  
Off Buzz Auto On  
to the 'Auto' position. The Alarm indicator will light.  
Ensurethatthevolumeissettothecorrectlevelandthedesiredstation  
is tuned in.  
The alarmwillsoundeverydayatthepresettimefor1hour 59minutes.  
ToturnoffthealarmuntilthenextdaypresstheAlarm/Offbutton. To  
turn off the alarm permanently set the Function switch to the 'Off'  
position.  
PM  
If you need any further advice, please call our Technical Helpline on :-  
02087580338(Mon-Fri)  
6
Snooze control  
Alarm /Off  
The radio or buzzer alarm can be silenced for 9 minutes by pressing the  
Snooze button. This sequence can be repeated during the alarm cycle (1  
hour59min). TheSnoozecontrolcanalsobeoperatedviathePillowTalk  
Remote - see following page.  
Sleep timer  
Alarm /O ff  
The radio can be set to turn off after a preset time has elapsed.  
Press and hold down the Sleep button until the desired time is reached  
(maximum 59 minutes in 1 minute steps). The radio will switch off after  
the sleep time has elapsed. To increase the sleep time by one hour,  
depress the hour button once whilst holding down the Sleep button. The  
clock will display the sleep time 1:59.  
To cancel the sleep function before the preset time has expired, press  
the Snooze button. The sleep function can also be cancelled via the  
Pillow Talk Remote - see following page.  
PM  
Dimmer  
High Low  
DimmerSwitch  
The Dimmer switch located on the left side of your clock radio will allow  
you to adjust the intensity of the clock display to suit room brightness.  
Headphones (on rear)  
AHeadphoneSocket (3.5mm)isprovidedforusewitheitherheadphones  
or an earpiece. Inserting a plug automatically mutes the internal loud-  
speaker.  
7
Pillow Talk Remote  
Your Pillow Talk Remote contains remote controls for Snooze and Sleep  
cancelfunctions. Thebuiltinloudspeakerallowsyoutolistentoyourclock  
radio or wake up to the radio or buzzer alarms without disturbing your  
partner. Ideal for listening to the late night Football or Cricket match.  
1. InserttheplugfromthePillowTalkRemoteintotheHeadphonesocket  
on the rear of your clock radio, the internal loudspeaker will be  
automatically muted.  
2. Place the Pillow Talk Remote under your Pillow with the slots in the  
loudspeakergrilleuppermost.  
3. SwitchontheradiobyslidingtheFunctionswitchtothe'On'position.  
4. Adjust the Volume control to a comfortable level.  
5. The radio or buzzer alarms can be set and operated as previously  
described, theonlydifferencebeingthatsoundswillbeviayourPillow  
TalkRemote.  
Remote snooze control  
Z
1. The radio or buzzer alarm can be silenced for 9 minutes by pressing  
the Snooze button on the Pillow Talk Remote. This sequence can be  
repeated during the alarm cycle (1 hour 59 min).  
Remote sleep timer cancel  
1. Tocancelthesleepfunctionbeforethepresettimehasexpired, press  
T M  
the Snooze button on the Pillow Talk Remote.  
PillowTalk  
If you need any further advice, please call our Technical Helpline on :-  
02087580338(Mon-Fri)  
8
General  
Fuse  
Do not allow this unit to be exposed to water or steam. It is recommended  
that the FM band be used wherever possible as better results in terms  
of quality and freedom from interference will usually be obtained than  
on the MW or LW bands.  
This apparatus must be protected by a 3A fuse (BS1362) in a 13A plug  
(BS1363). If another type of plug is used a 5A fuse should be fitted in the  
plug, adaptorordistributionboard.  
IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN.  
Mainssupply  
The CR9920 will operate from a supply of AC 230volts, 50Hz  
only.  
Back-upBattery(notnecessaryfortheunittofunction)  
For your convenience this product is supplied with a plug which is fitted  
with a fuse of the appropriate rating. If the plug supplied is not suitable  
for your socket outlet, it should be removed by unscrewing the plug top,  
the terminal screws, and removing the cable.  
Slidethebatterycovercatchinthedirectionofthearrow.Removethebattery  
cover.Fita9voltIECsize6LR61(6F22,PP3)orequivalent batteryintothe  
compartment. Replace the battery cover.  
Thetimeandalarmsettingswillberetainedduringatemporaryfailureofthe  
ACmainssupply. TheLEDdisplaywillnotbeoperational. Thedisplaywill  
be extinguished to conserve battery life.  
The correct style of plug to suit your household together with a correctly  
rated fuse should be fitted.  
IFINDOUBT-CONSULTAQUALIFIEDELECTRICIAN  
IMPORTANT. DO NOT make any connection to the larger terminal which  
is marked with the letter E or by the safety earth symbol  
Green or Green-and-yellow.  
or coloured  
(Underside)  
The wires in the mains lead are coloured in accordance with the  
following codes :-  
BLUE - NEUTRAL  
BROWN - LIVE  
As these colours may not correspond with the coloured markings  
identifying the terminals in your plug, proceed as follows:-  
The wire coloured BLUE must be  
connected to the terminal marked N  
E(Earth)  
orcolouredBLACK.  
Brown(Live)  
3 amp  
The wire coloured BROWN must be  
connectedtotheterminalmarkedLor  
colouredRED.  
L
Blue (Neutral)  
N
Cord  
9
Specifications  
Power Requirements  
Mains  
Circuit Features  
Loudspeaker  
75mm diameter 8 ohms  
0.3W RMS  
AC 230 volts, 50Hz  
only  
OutputPower  
Aerial System  
Back-up Battery  
IEC size 6LR61 (6F22, PP3)  
FM  
Wire Aerial  
Frequency Coverage  
FM  
87.5 - 108MHz  
MW  
LW  
Built-in Ferrite aerial  
Built-in Ferrite aerial  
MW  
LW  
525 - 1610kHz  
147-284kHz  
ROBERTSRADIOLIMITED  
PO BOX 130  
MEXBOROUGH  
SOUTH YORKSHIRE  
S64 8YT  
The Company reserves the right to amend the specification without notice.  
If you need any further advice, please call our Technical Helpline on :-  
02087580338(Mon-Fri)  
Guarantee  
This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component  
breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced free of  
charge.  
Theguaranteedoesnotcover:  
1. Damage resulting from incorrect use.  
2. Consequentialdamage.  
3. Receivers with removed or defaced serial numbers.  
Procedure:  
Any claim under this guarantee should be made through the dealer from whom the instrument was purchased. It is likely that your Roberts' dealer will  
beabletoattendtoanydefectquicklyandefficiently, butshoulditbenecessarythedealerwillreturntheinstrumenttothecompany’sservicedepartment  
forattention. IntheeventthatitisnotpossibletoreturntheinstrumenttotheRoberts'dealerfromwhomitwaspurchased, pleasecontactRobertsRadio  
Technical Services Department at the address shown below before taking further action.  
These statements do not affect the statutory rights of a consumer.  
ROBERTS RADIO TECHNICAL SERVICES DEPARTMENT  
97-99 Worton Road  
IsleworthMiddlesex  
TW7 6EG  
Technical Helpline:- 020 8758 0338 (Mon-Fri)  
Issue 1  

TP Link Cell Phone 1910010977 User Manual
StarTechcom HSB220SAT25B User Manual
Snapper "MR" SERIES 17 EMRP216517B User Manual
Seagate Computer Drive ST310212A User Manual
Samsung GT I5800L Series User Manual
Samsung GH68 27732A User Manual
Radio Shack 63 993 User Manual
Pantech G800 User Manual
Panasonic Cell Phone kx t7030 User Manual
Panasonic CD Player SL MP70 User Manual